Manuals / Extron electronic / Computer Equipment / Network Card

Extron electronic IPL T S2, IPL T S4, IPL T S1 setup guide IPL T S6

Models: IPL T S2 IPL T S6 IPL T S4 IPL T S1

1 45

Download 45 pages 51.59 Kb

Page 19

00-05-A6-00-00-02			COM1
00-05-A6-00-00-02
POWER	LAN		COM2
POWER
12V
12V		COM1	COM2
.5A MAX		COM1	COM2
.5A MAX
		TX RX	TX RX

IPL T S2

COM Ports

with Captive Screw Connectors

The IPL T S6 has four COM ports (3 thru 6) with captive screw connectors that are independent of COM ports 1 and 2, which have 9-pin D connectors.

00-05-A6-00-00-06			COM1

POWER	LAN		COM2

12V
		COM3 COM4	COM5 COM6
.5A MAX

COM Ports with 9-pin D Connectors

IPL T S6

TX RX TX RX TX RX TX RX

COM Ports

with Captive Screw Connectors

The IPL T S2 and S6 female captive screw connectors accept either 3-pole or 5-pole male captive screw connectors that are wired as shown in the illustrations below.

Tx

Rx

Gnd

Tx

Rx

Gnd

Tx

Rx

3-pole Captive Screw	5-pole Captive Screw
Connector	Connector

IPL T S Series Interfaces • Hardware Setup

2-7

Image 19

Extron electronic IPL T S2, IPL T S4, IPL T S1 setup guide IPL T S6

Contents

Interfaces IPL T S SeriesSafety Instructions English Precautions安全须知中文 Page Table of Contents Table of Contents, cont’d IPL T S Series Interfaces OneAbout this Manual IntroductionIPL T S Series Products IPL T S1 Introduction, cont’d Global Configurator Click the Download GCSWxxxxx.exe button Installing Global ConfiguratorClick the Global Configurator icon System requirementsIntroduction, cont’d Two Front Panel Hardware SetupRear Panel Local Area Network LAN Connection Hardware Setup, cont’d Power ConnectionSerial Device Connection RJ-45 Connector Straight-through CablePin D connector Hardware Setup, cont’dCaptive screw connector IPL T S6 Hardware Setup, cont’d Three Click the Add Driver Subscriptions button Software SetupCreating a Global Configurator Project File Step one download device driversClick the right arrow Subscribe button Step two create a new project Software Setup, cont’dIPL T S Series Interfaces Software Setup Click Edit Add Device Step three add a deviceClick Make this device a GlobalViewer Host if desired Click Auto Configure IP Address Step four define the location of the new device Step five save the new Global Configurator file Step six configure contacts Software Setup, cont’d Configuring a New DeviceClick Edit Contact Manager Click Edit Email Manager Step seven configure e-mailStep eight assign device drivers Driver Configuration tab opensClick Add Driver Step nine set scheduled actions and e-mail deliveries Click Apply Action IPL T S Series Interfaces Software Setup Click Apply Email/Contacts Step ten set monitored conditions Click Apply Condition Click ConditionsBuilding and Uploading a GC File Step eleven build the Global Configurator fileApply Email/Contacts Step twelve upload the Global Configurator file Click Tools Change Device Settings Step thirteen change device settings if desiredSet Mail Server..., Set Gateway..., Set Subnet Mask..., etc Step fourteen launch GlobalViewer Software Setup, cont’d Launching the GlobalViewer InterfaceIPL T S Series Interfaces Software Setup USA, Canada, South America Japan Central America Extron’s WarrantyExtron USA East Setup Guide Checklist