Manuals / Extron electronic / Computer Equipment / Network Card

Extron electronic IPL T S2, IPL T S4 Building and Uploading a GC File, Apply Email/Contacts

Models: IPL T S2 IPL T S6 IPL T S4 IPL T S1

1 45

Download 45 pages 51.59 Kb

Page 39

12.Click Next again to add an e-mail notification.

13.Select an e-mail message and contacts, and click

Apply Email/Contacts.

14.Click Done. The dialog box closes.

Building and Uploading a GC File

Before a Global Configuration (GC) file is active in the GlobalViewer interface, the GC file must be “built” and “uploaded” to a GlobalViewer host device.

The “build” process compiles all of the configuration data you have entered into the GC file for each A/V network device.

The “upload” process delivers the built (compiled) file to the GlobalViewer host device.

After the GC file has been uploaded to a host device, you can launch the GlobalViewer interface by entering the host device’s IP address in the address field of an Internet browser.

Step eleven: build the Global Configurator file

There are two Build commands:

•Build All Configurations — compiles configuration data for all devices in the GC file, including data for devices previously uploaded to a GlobalViewer host device.

•Build Changed Configurations — compiles configuration data only for devices that have been added or changed since the previous Build cycle.

To initiate a "Build (all)” process:

1. Click Build > Build All Configurations...

or click the Build All Configurations icon.

A Please Wait. Building Configuration(s)... dialog box opens and displays a progress bar while the GC file is being built.

IPL T S Series Interfaces • Software Setup 3-19

Image 39

Extron electronic IPL T S2, IPL T S4 Building and Uploading a GC File, Step eleven build the Global Configurator file

Contents

Interfaces IPL T S Series Safety Instructions English Precautions 安全须知中文 Page Table of Contents Table of Contents, cont’d IPL T S Series Interfaces One Introduction About this ManualIPL T S Series Products IPL T S1 Introduction, cont’d Global Configurator Click the Download GCSWxxxxx.exe button Installing Global ConfiguratorClick the Global Configurator icon System requirements Introduction, cont’d Two Front Panel Hardware Setup Rear Panel Local Area Network LAN Connection Hardware Setup, cont’d Power Connection Serial Device Connection RJ-45 Connector Straight-through Cable Hardware Setup, cont’d Pin D connectorCaptive screw connector IPL T S6 Hardware Setup, cont’d Three Click the Add Driver Subscriptions button Software SetupCreating a Global Configurator Project File Step one download device drivers Click the right arrow Subscribe button Step two create a new project Software Setup, cont’d IPL T S Series Interfaces Software Setup Step three add a device Click Edit Add DeviceClick Make this device a GlobalViewer Host if desired Click Auto Configure IP Address Step four define the location of the new device Step five save the new Global Configurator file Software Setup, cont’d Configuring a New Device Step six configure contactsClick Edit Contact Manager Click Edit Email Manager Step seven configure e-mail Driver Configuration tab opens Step eight assign device driversClick Add Driver Step nine set scheduled actions and e-mail deliveries Click Apply Action IPL T S Series Interfaces Software Setup Click Apply Email/Contacts Step ten set monitored conditions Click Apply Condition Click Conditions Step eleven build the Global Configurator file Building and Uploading a GC FileApply Email/Contacts Step twelve upload the Global Configurator file Step thirteen change device settings if desired Click Tools Change Device SettingsSet Mail Server..., Set Gateway..., Set Subnet Mask..., etc Step fourteen launch GlobalViewer Software Setup, cont’d Launching the GlobalViewer Interface IPL T S Series Interfaces Software Setup USA, Canada, South America Japan Central America Extron’s Warranty Extron USA East Setup Guide Checklist