Manuals / Extron electronic / Computer Equipment / Network Card

Extron electronic IPL T S1, IPL T S4, IPL T S6, IPL T S2 Step ten set monitored conditions

Models: IPL T S2 IPL T S6 IPL T S4 IPL T S1

1 45

Download 45 pages 51.59 Kb

Page 37

Step ten: set monitored conditions

The Monitor tab is used to respond with an action or e-mail to a specified condition or event. Actions vary by selected device, and include options such as Enable/Disable PINs, Lockout Front Panel, Time Delay, etc. Custom e-mails can be created and sent to specified e-mail addresses following specified conditions or events.

To add a monitored condition:

1. Click the Monitor tab.

2. Click the Add Monitor button.

The Monitored Condition Wizard opens (see below).

IPL T S Series Interfaces • Software Setup 3-17

Image 37

Extron electronic IPL T S1, IPL T S4, IPL T S6, IPL T S2 setup guide Step ten set monitored conditions

Contents

Interfaces IPL T S SeriesSafety Instructions English Precautions安全须知中文 Page Table of Contents Table of Contents, cont’d IPL T S Series Interfaces OneAbout this Manual IntroductionIPL T S Series Products IPL T S1 Introduction, cont’d Global Configurator Click the Global Configurator icon Installing Global ConfiguratorSystem requirements Click the Download GCSWxxxxx.exe buttonIntroduction, cont’d Two Front Panel Hardware SetupRear Panel Local Area Network LAN Connection Hardware Setup, cont’d Power ConnectionSerial Device Connection RJ-45 Connector Straight-through CablePin D connector Hardware Setup, cont’dCaptive screw connector IPL T S6 Hardware Setup, cont’d Three Creating a Global Configurator Project File Software SetupStep one download device drivers Click the Add Driver Subscriptions buttonClick the right arrow Subscribe button Step two create a new project Software Setup, cont’dIPL T S Series Interfaces Software Setup Click Edit Add Device Step three add a deviceClick Make this device a GlobalViewer Host if desired Click Auto Configure IP Address Step four define the location of the new device Step five save the new Global Configurator file Step six configure contacts Software Setup, cont’d Configuring a New DeviceClick Edit Contact Manager Click Edit Email Manager Step seven configure e-mailStep eight assign device drivers Driver Configuration tab opensClick Add Driver Step nine set scheduled actions and e-mail deliveries Click Apply Action IPL T S Series Interfaces Software Setup Click Apply Email/Contacts Step ten set monitored conditions Click Apply Condition Click ConditionsBuilding and Uploading a GC File Step eleven build the Global Configurator fileApply Email/Contacts Step twelve upload the Global Configurator file Click Tools Change Device Settings Step thirteen change device settings if desiredSet Mail Server..., Set Gateway..., Set Subnet Mask..., etc Step fourteen launch GlobalViewer Software Setup, cont’d Launching the GlobalViewer InterfaceIPL T S Series Interfaces Software Setup USA, Canada, South America Japan Central America Extron’s WarrantyExtron USA East Setup Guide Checklist