Hardware Setup, cont’d | Extron electronic IPL T S6, IPL T S4

Hardware Setup, cont’d

9-pin D connector

Connect any audio/video device using a serial cable with a

9-pin D connector to any one of the COM ports on the rear panel of an IPL T S Series interface.

00-05-A6-00-00-02			COM1
00-05-A6-00-00-02
POWER	LAN		COM2
POWER
12V
12V		COM1	COM2
.5A MAX		COM1	COM2
.5A MAX
		TX RX	TX RX

IPL T S2

COM Ports with 9-pin D Connectors

Pinouts for the 9-pin D connector are shown in the illustration and table below.

		5		1
		9	6
		9-Pin D Connector Pinouts
Pin	Function	RS-232	RS-422 RS-485
2	Receive Data/Receive Data -	RX	RX-	Data -
3	Transmit Data/Transmit Data -	TX	TX-	Tie 2 & 3
5	Signal Ground	GND	GND	GND
7	Request to Send/Transmit Data +	RTS	TX+	Data +
8	Clear to Send/Receive Data +	CTS	RX+	Tie 7 & 8

NIPL T S1 supports RS-232 only.

NWith RS-485 Data + can connect to pin 7 or 8. Data - can connect to pin 2 or 3.

Captive screw connector

The IPL T S2 has two COM ports with captive screw connectors that are common to the two 9-pin D connectors. Only one connector can be used for each COM port. If you use a COM port captive screw connector, its 9-pin D port is not accessible.

2-6 IPL T S Series Interfaces • Hardware Setup

Image 18

Extron electronic IPL T S6, IPL T S4, IPL T S1, IPL T S2 Hardware Setup, cont’d, Pin D connector, Captive screw connector

Contents

IPL T S Series Interfaces Precautions Safety Instructions English 安全须知中文 Page Table of Contents Table of Contents, cont’d One IPL T S Series Interfaces Introduction About this ManualIPL T S Series Products IPL T S1 Introduction, cont’d Global Configurator System requirements Installing Global ConfiguratorClick the Global Configurator icon Click the Download GCSWxxxxx.exe button Introduction, cont’d Two Hardware Setup Front Panel Rear Panel Hardware Setup, cont’d Power Connection Local Area Network LAN Connection RJ-45 Connector Straight-through Cable Serial Device Connection Hardware Setup, cont’d Pin D connectorCaptive screw connector IPL T S6 Hardware Setup, cont’d Three Step one download device drivers Software SetupCreating a Global Configurator Project File Click the Add Driver Subscriptions button Click the right arrow Subscribe button Software Setup, cont’d Step two create a new project IPL T S Series Interfaces Software Setup Step three add a device Click Edit Add DeviceClick Make this device a GlobalViewer Host if desired Click Auto Configure IP Address Step four define the location of the new device Step five save the new Global Configurator file Software Setup, cont’d Configuring a New Device Step six configure contactsClick Edit Contact Manager Step seven configure e-mail Click Edit Email Manager Driver Configuration tab opens Step eight assign device driversClick Add Driver Step nine set scheduled actions and e-mail deliveries Click Apply Action IPL T S Series Interfaces Software Setup Click Apply Email/Contacts Step ten set monitored conditions Click Conditions Click Apply Condition Step eleven build the Global Configurator file Building and Uploading a GC FileApply Email/Contacts Step twelve upload the Global Configurator file Step thirteen change device settings if desired Click Tools Change Device SettingsSet Mail Server..., Set Gateway..., Set Subnet Mask..., etc Software Setup, cont’d Launching the GlobalViewer Interface Step fourteen launch GlobalViewer IPL T S Series Interfaces Software Setup Extron’s Warranty USA, Canada, South America Japan Central America Setup Guide Checklist Extron USA East