Extron electronic IPL T S1, IPL T S4, IPL T S6, IPL T S2 guide

The IPL T Series products include:

IPL T S1

•12 VDC power supply

•RJ-45 Ethernet receptacle

•9-pin D RS-232 serial port

IPL T S2

•12 VDC power supply

•RJ-45 Ethernet receptacle

•Two 9-pin D RS-232, RS-422, or RS-485 serial ports

- or -

•Two 3.5 mm captive screw RS-232, RS-422, or RS-485 serial ports (common to the two 9-pin D serial ports).

IPL T S4

•12 VDC power supply

•RJ-45 Ethernet receptacle

•Four 9-pin D RS-232, RS-422, or RS-485 serial ports

IPL T S6

•12 VDC power supply

•RJ-45 Ethernet receptacle

•Two 9-pin D RS-232, RS-422, or RS-485 serial ports

•Four 3.5 mm captive screw RS-232, RS-422, or RS-485 serial ports (independent of the two 9-pin D serial ports)

IPL T S Series Interfaces • Introduction

1-3

Image 9

Extron electronic IPL T S1, IPL T S4, IPL T S6, IPL T S2 setup guide

Contents

Interfaces IPL T S Series Safety Instructions English Precautions 安全须知中文 Page Table of Contents Table of Contents, cont’d IPL T S Series Interfaces One Introduction About this ManualIPL T S Series Products IPL T S1 Introduction, cont’d Global Configurator Click the Global Configurator icon Installing Global ConfiguratorSystem requirements Click the Download GCSWxxxxx.exe button Introduction, cont’d Two Front Panel Hardware Setup Rear Panel Local Area Network LAN Connection Hardware Setup, cont’d Power Connection Serial Device Connection RJ-45 Connector Straight-through Cable Hardware Setup, cont’d Pin D connectorCaptive screw connector IPL T S6 Hardware Setup, cont’d Three Creating a Global Configurator Project File Software SetupStep one download device drivers Click the Add Driver Subscriptions button Click the right arrow Subscribe button Step two create a new project Software Setup, cont’d IPL T S Series Interfaces Software Setup Step three add a device Click Edit Add DeviceClick Make this device a GlobalViewer Host if desired Click Auto Configure IP Address Step four define the location of the new device Step five save the new Global Configurator file Software Setup, cont’d Configuring a New Device Step six configure contactsClick Edit Contact Manager Click Edit Email Manager Step seven configure e-mail Driver Configuration tab opens Step eight assign device driversClick Add Driver Step nine set scheduled actions and e-mail deliveries Click Apply Action IPL T S Series Interfaces Software Setup Click Apply Email/Contacts Step ten set monitored conditions Click Apply Condition Click Conditions Step eleven build the Global Configurator file Building and Uploading a GC FileApply Email/Contacts Step twelve upload the Global Configurator file Step thirteen change device settings if desired Click Tools Change Device SettingsSet Mail Server..., Set Gateway..., Set Subnet Mask..., etc Step fourteen launch GlobalViewer Software Setup, cont’d Launching the GlobalViewer Interface IPL T S Series Interfaces Software Setup USA, Canada, South America Japan Central America Extron’s Warranty Extron USA East Setup Guide Checklist