Local Area Network LAN Connection | Extron electronic IPL T S4

Hardware Setup, cont’d

Power Connection

To connect the power supply:

1. Insert the 2-pole captive screw connector into the power supply receptacle on the rear panel of the interface.

2. Connect the female end of the power supply AC cord into the power supply and connect the male plug end into a 110 VAC receptacle.

00-05-A6-00-00-01

12V

0.5 A

COM1LAN

Orange Captive Screw

Connector

Tie Wrap

Ground +12 VDC

External

Power Supply

(12 VDC, 1 A )

Local Area Network (LAN) Connection

Connect a patch (straight-through)Ethernet cable to the LAN receptacle on the rear panel if you are connecting the interface to a switch, hub, or router on your A/V network.

Connect a crossover Ethernet cable to the LAN receptacle on the rear panel if you are connecting the interface directly to a PC.

LAN Receptacle

00-05-A6-00-00-01

12V

0.5 A

COM1LAN

2-4 IPL T S Series Interfaces • Hardware Setup

Image 16

Extron electronic IPL T S4, IPL T S1, IPL T S6 Hardware Setup, cont’d Power Connection, Local Area Network LAN Connection

Contents

IPL T S Series Interfaces Precautions Safety Instructions English 安全须知中文 Page Table of Contents Table of Contents, cont’d One IPL T S Series Interfaces About this Manual IntroductionIPL T S Series Products IPL T S1 Introduction, cont’d Global Configurator Installing Global Configurator Click the Global Configurator iconSystem requirements Click the Download GCSWxxxxx.exe button Introduction, cont’d Two Hardware Setup Front Panel Rear Panel Hardware Setup, cont’d Power Connection Local Area Network LAN Connection RJ-45 Connector Straight-through Cable Serial Device Connection Pin D connector Hardware Setup, cont’dCaptive screw connector IPL T S6 Hardware Setup, cont’d Three Software Setup Creating a Global Configurator Project FileStep one download device drivers Click the Add Driver Subscriptions button Click the right arrow Subscribe button Software Setup, cont’d Step two create a new project IPL T S Series Interfaces Software Setup Click Edit Add Device Step three add a deviceClick Make this device a GlobalViewer Host if desired Click Auto Configure IP Address Step four define the location of the new device Step five save the new Global Configurator file Step six configure contacts Software Setup, cont’d Configuring a New DeviceClick Edit Contact Manager Step seven configure e-mail Click Edit Email Manager Step eight assign device drivers Driver Configuration tab opensClick Add Driver Step nine set scheduled actions and e-mail deliveries Click Apply Action IPL T S Series Interfaces Software Setup Click Apply Email/Contacts Step ten set monitored conditions Click Conditions Click Apply Condition Building and Uploading a GC File Step eleven build the Global Configurator fileApply Email/Contacts Step twelve upload the Global Configurator file Click Tools Change Device Settings Step thirteen change device settings if desiredSet Mail Server..., Set Gateway..., Set Subnet Mask..., etc Software Setup, cont’d Launching the GlobalViewer Interface Step fourteen launch GlobalViewer IPL T S Series Interfaces Software Setup Extron’s Warranty USA, Canada, South America Japan Central America Setup Guide Checklist Extron USA East