Step fourteen launch GlobalViewer | Extron electronic IPL T S6

Software Setup, cont’d

Launching the GlobalViewer Interface

GlobalViewer is a graphical user interface that is generated by Global Configurator (GC). When a GC file is built and uploaded to a GlobalViewer host device, you can launch the GlobalViewer interface by opening an Internet browser and entering the host device’s IP address in the browser address field.

Once the GlobalViewer interface is launched, you can monitor and control all of the devices on your A/V network from the GlobalViewer host device.

Step fourteen: launch GlobalViewer

To launch GlobalViewer:

1. Open an Internet browser.

2. Enter the IP address of a GlobalViewer host device in the Address field, and press the keyboard's Enter key.

A window appears similar to the one shown below.

3-22 IPL T S Series Interfaces • Software Setup

Image 42

Extron electronic IPL T S6 Software Setup, cont’d Launching the GlobalViewer Interface, Step fourteen launch GlobalViewer

Contents

IPL T S Series Interfaces Precautions Safety Instructions English 安全须知中文 Page Table of Contents Table of Contents, cont’d One IPL T S Series Interfaces Introduction About this ManualIPL T S Series Products IPL T S1 Introduction, cont’d Global Configurator System requirements Installing Global ConfiguratorClick the Global Configurator icon Click the Download GCSWxxxxx.exe button Introduction, cont’d Two Hardware Setup Front Panel Rear Panel Hardware Setup, cont’d Power Connection Local Area Network LAN Connection RJ-45 Connector Straight-through Cable Serial Device Connection Hardware Setup, cont’d Pin D connectorCaptive screw connector IPL T S6 Hardware Setup, cont’d Three Step one download device drivers Software SetupCreating a Global Configurator Project File Click the Add Driver Subscriptions button Click the right arrow Subscribe button Software Setup, cont’d Step two create a new project IPL T S Series Interfaces Software Setup Step three add a device Click Edit Add DeviceClick Make this device a GlobalViewer Host if desired Click Auto Configure IP Address Step four define the location of the new device Step five save the new Global Configurator file Software Setup, cont’d Configuring a New Device Step six configure contactsClick Edit Contact Manager Step seven configure e-mail Click Edit Email Manager Driver Configuration tab opens Step eight assign device driversClick Add Driver Step nine set scheduled actions and e-mail deliveries Click Apply Action IPL T S Series Interfaces Software Setup Click Apply Email/Contacts Step ten set monitored conditions Click Conditions Click Apply Condition Step eleven build the Global Configurator file Building and Uploading a GC FileApply Email/Contacts Step twelve upload the Global Configurator file Step thirteen change device settings if desired Click Tools Change Device SettingsSet Mail Server..., Set Gateway..., Set Subnet Mask..., etc Software Setup, cont’d Launching the GlobalViewer Interface Step fourteen launch GlobalViewer IPL T S Series Interfaces Software Setup Extron’s Warranty USA, Canada, South America Japan Central America Setup Guide Checklist Extron USA East