Extron electronic MAV 48, MAV 88, MAV 84, MAV 44 manual Example 3 Remove a tie from a set of ties

Example 3: Remove a tie from a set of ties

This example shows two similar operations:

•Removing an audio tie from a set of ties on an audio/video switcher

•Removing a tie on a video-only switcher

The following steps show an example in which an existing tie is removed from the current configuration. The example shows the front panel indications that result from your actions.

This example assumes that you have performed example 1 and example 2.

1. Audio/video switchers only — Select audio only for the tie (figure 3-14).

Press the button to cycle through the selections.

I/O

The video LED is off when video is deselected. VID

The audio LED lights when audio is selected. AUD

Figure 3-14 — Select audio only

2. Press and release the Input 5 button (figure 3-15).

Press and release the Input 5 button.

4	INPUTS			2		4	OUTPUTS
	5	6	1		3		5	6	7	8

The Input 5 LED lights to indicate that input 5 is selected.

On an audio/video MAV, the Output 3, Output 4, and Output 8 LEDs light to indicate the ties created in example 1.

Figure 3-15 — Select an input

3. Press and release the Output 4 button (figure 3-16).

Press and release the Output 4 button.

OUTPUTS

1 2 3 4 5 6 7 8

The Output 4 LED goes out to indicate that the selected input will be untied from this output.

Figure 3-16 — Deselect the output

4. Press and release the Enter button (figure 3-17).

Press the Enter button to confirm the configuration change.

ENTER

The selected input's LED and the remaining tied outputs' LEDs light steadily for approximately 1 second to indicate the tie and then go out. (The deselected output's LED is already out.)

INPUTS		OUTPUTS
5	3	4	8

1 second

Figure 3-17 — Press the Enter button

MAV 44 / 48 / 84 / 88 Matrix Switchers • Operation 3-11