Extron electronic MAV 84 manual Example 4 View ties by selecting an input, Select video and audio

Example 4: View ties by selecting an input

The following steps show an example of viewing the video and audio, audio-only, and video-only ties in the current configuration by selecting an input. The example shows the front panel indications that result from your actions.

This example assumes that you have performed example 1, example 2, and example 3.

1. Audio/video switchers only — Select both video and audio for viewing (figure 3-19).

Press the button to cycle through the selections.

I/O

The video LED lights when video is selected. VID

The audio LED lights when audio is selected. AUD

Figure 3-19 — Select video and audio

2. Press and release the Input 5 button (figure 3-20).

Press and release the Input 5 button.

INPUTS

1 2 3 4 5 6 7 8

The Input 5 LED lights to indicate that input 5 is selected.

OUTPUTS

1 2 3 4 5 6 7 8

Video-only switcher — The Output 1, Output 3, and Output 8 LEDs light to indicate the ties created in examples 1, 2, and 3.

Audio/video switcher — The Output 1, Output 3, Output 4, and Output 8

LEDs light to indicate the video ties created in examples 1, 2, and 3.

The audio LED blinks to indicate that for at least one tie audio is routed from a different source or not tied at all (audio breakaway).

I/O

VID +dB

AUD - dB

Figure 3-20 — Select an input

Steps 3 and 4 can be performed on an audio/video switcher only. If you have a video-only switcher, allow the 5-second input and output button timeout to deselect the input.

MAV 44 / 48 / 84 / 88 Matrix Switchers • Operation 3-13