Extron electronic MAV 88, MAV 84, MAV 44, MAV 48 manual Viewing the configuration, Video

Operation, cont’d

The current configuration (figure 3-18) is now:

•Video —

(Video-only switcher) — Input 5 tied to output 1, output 3, and output 8 (Audio/video switcher) — Input 5 video tied to output 1, output 3, output 4, and output 8

•Audio — (Audio/video switcher) Input 5 audio tied to output 3 and output 8

Input 5 video tied

to outputs 1, 3, 4, and 8.

Input 5 audio tied to outputs 3 and 8.

Input

5

1

3

4 Output

8 Video Audio

Figure 3-18 — Example 3, final configuration, audio switcher

Viewing the configuration

The current configuration (all active ties) can be viewed using the front panel buttons as follows:

1.	Select video, audio, or both to view by pressing the I/O button.
2.	Press and release an input or output button.
	a.	Press and release an input button — All of the buttons for outputs that
		are tied to the selected input light. If the Audio LED is flashing, it
		indicates that there are audio-only ties (audio breakaway).
		Allow the 5-second timeout to deselect the input buttons before you select an
		output button. If an input button is still selected, the indications will not be as
		described and you may inadvertently establish potential ties that could be
		created by pressing the Enter button.
	b.	Press and release an output button — The button for the tied input and
		all of the buttons for outputs that are also tied to the same input light. If
		the Audio LED is flashing, it indicates that there are audio-only ties
		(audio breakaway).
		To see all ties of the current configuration, press and release each input or
		output button, one at a time, with the Video LED and the Audio LED lit.
3.	After approximately 5 seconds, the LEDs for the input and tied outputs go
	out.

3-12 MAV 44 / 48 / 84 / 88 Matrix Switchers • Operation