Getting Started 2
Turning the Meter on
1. | Viewing Position | 2. | Alternate Viewing Position |
|
|
| Pull End Out and Towards You. |
|
|
| Then Slide to Left. |
|
| 4. | Removal Position |
3. | Carrying Position |
| (to Remove, Pull Ends Out) |
|
| ||
|
|
| aam03f.eps |
Figure
If you have not already done so, plug the line cord into the connector on the rear of the meter. The meter will operate on any line voltage between 90 V ac and 264 V ac without adjustment, and any frequency between 45 and 440 Hz. However, it is only warranted to meet published specifications at 50/60 Hz.
Turning the Meter on
To turn the meter on, press in the green, POWER button located on the
When the meter is turned on, the primary and secondary displays light for about 4 seconds while the instrument performs an internal
If any front panel button other than Eis held down while the
After the meter completes the
Using the Pushbuttons
The pushbuttons on the front panel select meter functions and operations. A summary of basic pushbutton operations is shown in Figure
Pushbuttons can be used in three ways. You can:
•Press a single button to select a function or operation. EXAMPLE: Press Zto select volts ac for the primary display. Press a combination of buttons, one after the other.