Installation 2
Introduction
Warning
The 5725A amplifier is capable of supplying lethal voltages. Do not touch the 5700A output terminals. Read this section before operating the 5725A.
Introduction |
This section provides instructions for unpacking and installing the 5725A. Procedures for line voltage selection, fuse replacement, and connection to line power and the 5700A Calibrator are provided here. Read this section before operating the 5725A.
Instructions for connecting cables to a UUT (Unit Under Test) are in Section 4 of the 5700A Operator Manual.
Unpacking and Inspection |
The 5725A is shipped in a container that is specially designed to prevent damage during shipping. Inspect the 5725A carefully for damage, and immediately report any damage to the shipper. Instructions for inspection and claims are included in the shipping container.
If you need to reship the 5725A, use the original container. If it is not available, you can order a new container from Fluke by identifying the amplifier’s model and serial number.
When you unpack the 5725A, check for all the standard equipment listed in Table
Line power cords available from Fluke are listed in Table
Table
Item
Amplifier
Line Power Cord
Shielded 5700A/5725A Interface Cable
5725A Instruction Manual
Spare 4A, 250V Fuse
Certificate of Calibration
Model or Part Number
5725A
(See Table
(None)