Fujitsu DVD Player manual Video Problems, page 6 for location, page 33 for more information

		T r o u b l e s h o o t i n g
Problem	Possible Cause	Possible Solutions
Video Problems
The built-in display is	Something is pushing on the	Clear the Closed Cover switch. (See figure 2-5 on
blank when you turn on	Closed Cover switch.	page 6 for location)
your LifeBook notebook.
	The notebook is set for an	Pressing [F10] while holding down the [FN] key
	external monitor only.	allows you to change your selection of where to
		send your display video. Each time you press the
		combination of keys you will step to the next
		choice. The choices, in order are: built-in display
		only, external monitor only, both built-in display
		and external monitor.
	The angle of the display	Move the display and the brightness control until
	and the brightness settings	you have adequate visibility.
	are not adequate for your
	lighting conditions.
	The power management time-	Press any button the keyboard, or move the mouse
	outs may be set for very short	to restore operation. If that fails, push the Suspend/
	intervals and you failed to	Resume button. (The display may be shut off by
	notice the display come on	Standy mode, Auto Suspend or Video Timeout)
	and go off again.
The LifeBook notebook	Power On Self Test (POST)	Contact your support representative.
turned on with a series of	has detected a failure which
beeps and your built-in	does not allow the display
display is blank.	to operate.
The display goes blank by	The notebook has gone into	Press any button on the keyboard, or move the
itself after you have been	Video timeout, Standby mode,	mouse to restore operation. If that fails, push the
using it.	Suspend mode or Save-to-Disk	Suspend/Resume button. Check your power
	mode because you have not	management settings, or close your applications
	used it for a period of time.	and go to the Power Savings menu of the setup
		utility to adjust the timeout values to better suit
		your operation needs. (See BIOS Setup Utility on
		page 33 for more information)
	Something is pushing on the	Check the Closed Cover switch. (See figure 2-5 on
	Closed Cover switch.	page 6 for location)
	The power management time-	Press any button on the keyboard, or move the mouse
	outs may be set for very short	to restore operation. If that fails, push the Suspend/
	intervals and you failed to	Resume button. (The display may be shut off by
	notice the display come on	Standby Mode, Auto Suspend or Video Timeout)
	and go off again.
Your system display won’t	The system may be password-	Check the status indicator panel to verify that the
turn on when the system is	protected.	Security icon is blinking. If it is blinking, enter your
turned on or when the		password.
system has resumed.
The Built-in Display does	A foreign object, such as a	Remove all foreign objects from the keyboard.
not close.	paper clip, is stuck between the
	display and the keyboard.

69