Fujitsu MPG3XXXAT manual Execute Device Diagnostic

At command issuance (I/O registers setting contents)

1F7H(CM)	1	1	0	0		0	1	1	0
1F6H(DH)	×	×	×		DV			xx
1F5H(CH)						xx
1F4H(CL)						xx
1F3H(SN)						xx
1F2H(SC)				Sector count/block
1F1H(FR)						xx

At command completion (I/O registers contents to be read)

1F7H(ST)				Status information
1F6H(DH)	×	×	×		DV	xx
1F5H(CH)					xx
1F4H(CL)					xx
1F3H(SN)					xx
1F2H(SC)				Sector count/block
1F1H(ER)				Error information

After power-on or after hardware reset, the READ MULTIPLE and WRITE MULTIPLE command operation are disabled as the default mode.

Regarding software reset, the mode set prior to software reset is retained after software reset.

The parameters for the multiple commands which are posted to the host system when the IDENTIFY DEVICE command is issued are listed below. See Subsection 5.3.2 for the IDENTIFY DEVICE command.

Word 47 = 8010: Maximum number of sectors that can be transferred per interrupt by the READ MULTIPLE and WRITE MULTIPLE commands are 16 (fixed).

Word 59 = 0000: The READ MULTIPLE and WRITE MULTIPLE commands are disabled.

=01xx: The READ MULTIPLE and WRITE MULTIPLE commands are enabled. "xx" indicates the current setting for number of sectors that can be transferred per interrupt by the READ MULTIPLE and WRITE MULTIPLE commands.

e.g. 0110 = Block count of 16 has been set by the SET MULTIPLE MODE command.

(16)EXECUTE DEVICE DIAGNOSTIC (X'90')

This command performs an internal diagnostic test (self-diagnosis) of the device. This command usually sets the DRV bit of the Drive/Head register is to 0 (however, the DV bit is not checked). If two devices are present, both devices execute self-diagnosis.

5 - 40 C141-E110-02EN