Fujitsu MPG3XXXAT manual

5.3	Protocol for command abort	5 - 78
5.4	WRITE SECTOR(S) command protocol	5 - 79
5.5	Protocol for the command execution without data transfer	5 - 80
5.6	Normal DMA data transfer	5 - 82
5.7	Ultra DMA termination with pull-up or pull-down	5 - 93
5.8	PIO data transfer timing	5	- 94
5.9	Multiword DMA data transfer timing (mode 2)	5 - 95
5.10	Initiating an Ultra DMA data in burst	5 -96
5.11	Sustained Ultra DMA data in burst	5 -100
5.12	Host pausing an Ultra DMA data in burst	5 - 101
5.13	Device terminating an Ultra DMA data in burst	5 - 102
5.14	Host terminating an Ultra DMA data in burst	5 - 103
5.15	Initiating an Ultra DMA data out burst	5 - 104
5.16	Sustained Ultra DMA data out burst	5 - 105
5.17	Device pausing an Ultra DMA data out burst	5 - 106
5.18	Host terminating an Ultra DMA data out burst	5 - 107
5.19	Device terminating an Ultra DMA data out burst	5 - 108
5.20	Power-on Reset Timing	5	- 109
6.1	Response to power-on	6	- 2
6.2	Response to hardware reset	6	- 3
6.3	Response to software reset	6	- 4
6.4	Response to diagnostic command	6 - 5
6.5	Address translation (example in CHS mode)	6 - 7
6.6	Address translation (example in LBA mode)	6 - 8
6.7	Sector slip processing	6	- 11
6.8	Alternate cylinder assignment	6	- 12
6.9	Data buffer configuration	6	- 13

xii C141-E110-02EN