3.3 fi-5000N's Settings and Connecting to the Network

1. Turn on the power of the scanner and fi-5000N.

Refer to the scanner manual for details on turning on the power of the scanner.

Turn on the fi-5000N by pressing the "" of the power switch located at the back of the fi- 5000N.

Power OFF

Power ON

ATTENTION

To change the language setting, refer to "3.4 Changing the Language Set- ting" (page 18)

2.When "The network cable is disconnected" appears on the fi-5000N’s Message Dis- play, connect the network cable to the network connector at the back of fi-5000N.

The following screen appears.

If the network support DHCP and the process goes success- fully, "Place your finger on the sensor." message appears.

HINT

When the above screen remains still, open the

 

cover of the fi-5000N, and press the [ESC]

key.

⇒The following screen appears, and the IP address obtaining operation is canceled.

Obtaining IP address

from DHCP server...

Cancel:[ESC]

Cannot obtain IP address from DHCP server.

Setup:[SET]

14