3.9 Host Connection Time-out

When a login is performed with authentication by fingerprint or PIN, the fi-5000N waits a certain period of time for a connection response from the host computer. You can specify this waiting time by following the procedure below.

If there is no response from the host computer during the specified waiting time, "Host Connection failure due to time-out" message will appear on the Message Display.

The default waiting time for the host’s connection response is 3 seconds.

1.Open the fi-5000N’s cover and press the [SET] key.

The following settings screen appears.

Setup

Register Finger

Change PIN Code

Show Network Config

2. With the [L] key, select "Administrator Setup", and press the [ENT] key.

The screen to enter the Administrator's PIN (personal iden-

 

tification number) appears.

PIN:_

 

Cancel:[ESC]

3. Enter the Administrator PIN (the default setting is "5000"), and press the [ENT] key.

The following screen appears.

Administrator Setup

Configure Network

Pull Mode Authentic

Auto Logout Time

4. With the [L] key, select "Host time-out", and press the [ENT] key.

The following screen appears.

Host connection time-out (1-60)[sec]

3_

5.With the keyboard, input the waiting time before the time-out is performed (from 0 to 60 seconds) and press the [ENT] key.

The following screen appears.

Host connection time-out setting changed

With this, the host connection time-out setting is done.

The setting will take effect from the next login.

24