6.4 Changing the User’s PIN
The initial user’s PIN value is set by the Administrator during the user registration. However the user is able to change his/her own PIN.
Change the user's PIN following the procedure below.
1.When "Place your finger on the sensor" is displayed on the
The following settings screen appears.
Setup
Register Finger
Change PIN Code
Show Network Config
2. With the [L] key, select "Change PIN Code", and press the [ENT] key.
The "Select User" screen appears as follows.
Select User 1(user's name) 2(user's name) 3(user's name)
3.Select the registered user with the [K], [L] keys, and press the [ENT] key.
The next screen appears, and the PIN is prompted.
Current PIN:
_
Cancel:[ESC]
4. Enter the current PIN and press the [ENT] key.
If the PIN does not match, the message "The PIN is incor- rect" appears and you are prompted to enter again. If the PIN matches, the message "New PIN:" appears.
5. Enter the new PIN and press the [ENT] key.
For confirmation,
If the registration of the new PIN is successfully done, the following screen appears.
New PIN:
_
Cancel:[ESC]
PIN has been changed
With this, the user's PIN is changed.
76