3.7 Pull Mode User Authentication Settings
You can set the user authentication function on or off, when performing a "Pull" mode scanning. User authentication function is enabled as the default setting.
HINT |
| There are 2 ways to perform scanning: "Push" mode and "Pull" mode scan- |
|
| ning. |
|
| In "Push" mode, scanning is started by pressing a scanner’s button ([Scan] |
|
| |
|
| or [Send to] button) and the scanned image data is sent ("Pushed") to the |
|
| PC. |
|
| On the other hand, in "Pull" mode, scanning is started from the PC by using |
|
| the scanning application which captures ("Pulls") the image data from the |
|
| scanner. |
|
| The "Push" mode scanning requires user authentication (by fingerprint or |
|
| PIN) to identify the sender, while the "pull" mode does not necessarily |
|
| require user authentication. For security measures, you can enable the |
|
| user authentication function. |
To configure the "pull" mode user authentication, follow the procedure below.
1.Open the
The following settings screen appears.
Setup
Register Finger
Change PIN Code
Show Network Config
2. With the [L] key, select "Administrator Setup", and press the [ENT] key.
The screen to enter the Administrator's PIN (personal iden- |
|
tification number) appears. | PIN:_ |
| Cancel:[ESC] |
3. Enter the Administrator PIN (the default setting is "5000"), and press the [ENT] key.
The following screen appears.
Administrator Setup
Configure Network
Pull Mode Authentic
Auto Logout Time
3
| 21 | |
|