Servicing Customer-Replaceable Units 113
▼ Add FB-DIMMs
If you are upgrading the system with additional FB-DIMMs, use this procedure.
Before you begin, complete these tasks:
■Read the section, “Safety Information” on page 63.
■Read the sections, “FB-DIMM Configuration” on page 113 and “FB-DIMM Device
Identifiers” on page116.
■Power off the server using one of the methods described in the section, “Powering
Off the System” on page 67.
■“Extend the Server to the Maintenance Position” on page 70
■“Perform Electrostatic Discharge – Antistatic Prevention Measures” on page73
■“Remove the Top Cover” on page73
■“Remove a CMP/Memory Module” on page104
1. Unpackage the FB-DIMMs and place them on an antistatic mat.
2. Ensure that the ejecto r tabs are in the open position.
3. Line up the FB-DIMM with the connector.
Align the FB-DIMM notch with the key in the connector. This ensures that the
FB-DIMM is oriented correctly.
4. Push the FB-DIMM into the connector until the ejector tabs lock the FB-DIMM
in place.
If the FB-DIMM does not easily seat into the connector, verify that the orientation
of the FB-DIMM is correct. If the orientation is reversed, damage to the FB-DIMM
might occur.
5. Repeat Step 2 through Step 4 until all the FB-DIMMs are installed.
Next Steps
■“Install a CMP/Memory Module” on page105
■“Install the Top Cover” on page154
■“Slide the Server Into the Rack” on page 155
■“Power On the Server” on page157
FB-DIMM Configuration
This topic includes the following:
■“Supported FB-DIMM Configurations” on page114