Manufacturer’s notes
A26391-K136-Z120-2-7619 13
!AVERTISSEMENT:
Pour assurer la sécurité, les utilisateurs doivent vérifier que la prise de terre du service
d’électricité, les lignes télphoniques et les conduites d’eau métalliques sont connectées
ensemble. Les utilisateurs NE doivent PAS tenter d’établir ces connexions eux-mêmes,
mais doivent contacter les services d’inspection d’instal l at i ons électriques appropriés ou
un électricien. Ceci peut être particulièrement important en régions rurales.
UL Notice
This unit requires an AC adapter to operate. Use only UL Listed Class 2 adapter, output rating 19V
DC, 4.22 A. Refer to the illustration below for the correct AC Adapter output polarity:
!CAUTION:
To reduce the risk of fire, use only #26 AWG or larger telecommunications line cord.
For Authorized Repair Technicians Only
!CAUTION:
For continued protection against risk of fire, replace only with the same ty pe and rat ing
fuse.
!WARNING:
Danger of explosion if Lithium (CMOS) battery is incorrectly replaced. Replac e only with
the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer’s instruction.

FCC Regulatory information for notebooks with radio device

Federal Communications Commission statement
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause interference, and, (2) This device must accept any interference,
including interference that may cause undesired operation of this device.
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B di gi t al device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates , us es, and can
radiate radio frequency energy. If not installed and used in accordance with the instruc tions, it may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.