Gaggia 14101-8002 manual Description of parts, Instructions for the power supply cord, Preparation

Description of parts:

FIG. 01

1Main switch

2Coffee dispensing button-1 strong/2 weak

3Coffee dispensing button-1 weak/2 weak

4Hot water supply button

5Steam supply light

6Dose programming/Manual dispensing button

7Correct temperature light

8Turbo frother steam nozzle (removeable)

9Filterholder

101 cup filter (or coffee pod)

112 cup filter

12Basin (removable)

13“Perfect crema” device (OPTION)

14Brewing head

15Filterholder gasket

16Shower disc holder

17Shower disc

18Tamper

19Power cable and plug

20Measuring spoon

21Delivery spout

22Tank cover

23Grid (removable)

24Cappuccino maker kit (OPTION)

25Steam/hot water knob

26Removable water tank

27Overflowing protection hole

28Anti-fingerprint cleaner for stainless steel

29Level indicator for the basin

Instructions for the power supply cord

AA short power-supply cord is provided to reduce risks of getting tangled up or tripping over a longer cord.

BLonger extension cords are available and may be used if care is exercised in their use.

CIf a long extension cord is used:

1the marked electrical rating of the extension cord should be at least as great as the electri- cal rating of the appliance.

2if the appliance is of the grounded type, the extension cord should be a grounding type

3the cable does not hang from the table to avoid the risk of getting caught up in it.

ENGLISH

Preparation:

1.Remove the water tank cover (22) and fill with cold water to the MAX line indicated on tank (26). See FIG. 2.

N.B.: Near the word MAX on the tank there is the overflowing safety hole (27) in case of tank overfilling.

The water tank can also be removed, after removing the tank cover (22) using the handle.

Re-install tank with water and cover (22).

2.Insert plug (19) into a suitable wall outlet (see point 1 under “Caution”).

3Push the main switch (1). The temperature light (7) will flash until the temperature is reached; when the temperature is reached the light will remain on.

The lights of buttons 2 - 3 - 5 - 6 will remain on in a fixed way (stand-by mode).

Starting up

This procedure fills the water boiler with fresh water.

This should be done whenever the machine is switched on.

This machine, featuring a pump to brew coffee, is equipped with a self-priming system.

Put an empty cup below the steam frother (8), press the hot water button (4) and turn the steam knob (25) clockwise.

You will hear the noise of the enabled pump and after a few seconds water will come down from steam rod (8).

When the cup is filled close the steam knob (25) and press the hot water button (4) again.

The Gaggia machine is now ready to be used.

• 9 •