8Remove the mounting rails from the hard drive.

9Place the old drive in an antistatic bag or container, then place the new hard drive on a static-free surface with the top up and the connectors facing you.

10Install the two drive mounting rails on the new hard drive, making sure the front rail extensions are to the front of the device. The rails are labeled.

11Set the drive jumpers to the appropriate settings (refer to your drive documentation for jumper settings.)

12Align the rails with the open bay at the bottom of the drive stack, then slide the drive into the stack until the locking tabs snap into place (make sure that the data and power connectors on the drive face the inside of the server).

13Connect the power and data cables to the drive. (See the drive documentation for proper cable orientation.)

14Replace the bezel. (See “Replacing the bezel” on page 28.)

15Close the case. (See “Closing the case” on page 27.)

16Reconnect the power cord, the modem cord, and all other external peripheral devices, then turn on the system.

34Replacing and Adding System Components