11Connect any cables to the card (see card documentation for proper cable orientation).

12Replace the bezel. (See “Replacing the bezel” on page 28.)

13Close the case. (See “Closing the case” on page 27.)

14Reconnect the power cord, the modem cord, and all other peripherals, then turn on the system.

You may need to reconfigure the server after replacing an expansion card. You may also need to install upgrade software that came with the card. Check the card documentation for additional information.

Adding an expansion card

To add an expansion card:

1Set any jumpers and switches on the card according to the card instructions, if necessary.

2Turn off the system and disconnect the power cord, modem cord (if installed), and all external peripheral devices.

3Observe all safety and static electricity precautions. (See “Preventing static electricity discharge” on page 22.)

4Remove the bezel. (See “Removing the bezel” on page 25.)

5Remove the left side cover panel. (See “Removing the side cover panel” on page 26.)

6Locate an available slot and remove the slot cover by pressing the expansion card retention clip back through the back panel.

7Pull out the slot cover.

Expansion cards

65