6Make sure the hooks on the bottom of the handle engage the edge of the drive bay, then firmly close the handle.
7Secure the drive by locking the drive carrier with the hex key.
Replacing the CD drive
The CD drive is located in one of the
To replace the CD drive:
1Turn off the system and disconnect the power cord, modem cord (if installed), and all external peripheral devices.
2Observe all safety and static electricity precautions. (See “Preventing static electricity discharge” on page 22.)
3Remove the bezel. (See “Removing the bezel” on page 25.)
4Remove the left side cover panel. (See “Removing the side cover panel” on page 26.)
5Locate the
6Remove the power and data cables from the back of the drive, noting their locations and orientations. (You will reconnect these cables after you install the new drive.)
7Disengage the rail locking tabs by pressing in on both front rail extensions, then move the drive slightly out of the bay by pushing on the back of the drive.
Drives 47