Error Message

Solutions

 

 

Diskette drive reset failed.

Enter the BIOS Setup utility, then verify the

 

diskette drive parameters.

 

Check the diskette drive cables. Make sure

 

Pin 1 on the cable aligns with Pin 1 on the

 

connector.

 

 

Diskette read failed - strike

Make sure that the boot disk contains the

F1 to retry boot.

Command.com file.

 

Use the configuration utility (if applicable) to

 

make sure that your drive or controller

 

configuration.

 

Press F1 to try to restart the computer.

 

 

Gate A20 failure.

You may have an XT keyboard connected to

 

an AT system or vice versa. Make sure that

 

the keyboard is configured to work with the

 

appropriate system. Some keyboards have a

 

switch to select either AT or XT.

 

 

Hard disk controller failure.

Make sure that the hard disk cable is properly

 

connected.

 

Open the BIOS Setup utility program, then

 

make sure that the correct drive type is

 

selected.

 

 

Hard disk controller failure

The drive controller may be defective. Press

- press F1 to try reboot.

F1 to try to restart the computer.

 

Try running Fdisk and DOS Format. For more

 

information, refer to your DOS

 

documentation.

 

 

Insert bootable media

See “The IDE drive is not recognized by the

device.

system” on page 89 for a possible solution.

 

See “The SCSI drive is not recognized by the

 

system” on page 89 a possible solution.

 

Backup your files as soon as possible.

 

 

Insufficient disk space.

Check the free space on the disk volume. If

 

the volume is full or almost full, remove

 

unnecessary files.

 

 

Invalid configuration

Enter the BIOS Setup utility, then verify the

information…

parameter values.

 

 

Error messages

101