Replacing or adding a processor

The system is compatible with the Intel® Pentium® III 667 and 733 MHz and faster processors with 133 MHz front-side bus (FSB). Up to two processors may be installed in the system.

When replacing a processor, or adding an additional processor, order a Pentium III processor upgrade kit from Gateway. The kit includes the Pentium III processor, a fan/heatsink, and a disposable electrostatic wrist strap.

Caution

A heatsink or fansink must be installed on each processor.

 

Installing a processor without a heatsink or fansink could

 

result in damage to, or failure of the processor.

 

 

To replace a processor:

1Turn off the system and disconnect the power cord and modem cord (if installed) and all other external peripheral devices.

2Open the case by following the instructions on page 17. (See “Preventing static electricity” on page 15.)

3Disconnect the power supply cable of the processor fan from the CPU fan connector on the system board.

4Place the head of a flat-bladed screwdriver behind the tab on one side of the processor retention bracket holding the processor to be removed.

Screwdriver

Tab

5Push the handle of the screwdriver toward the processor. When the tab that locks the processor in place opens, lift up slightly on the side of the processor.

28System Components