
To install an additional hard drive:
1Turn off the system and disconnect the power cord and modem cord, if installed.
2Open the case by following the instructions on page 17. (See “Preventing static electricity” on page 15.)
3Place the new hard drive on a
4Install two small, plastic drive mounting rails (“L” rail on the left and “R” rail on the right) to the new hard drive, making sure the front rail extensions are towards the front of the device. Align the wire retention clips to the mounting holes in the drive and pressing the rails to the sides of the drive.
5Align the rails with an open bay in the bottom drive cage, and slide the drive into the chassis until the locking tabs snap into place.
6Connect the data and power cables to the drive. (See drive documentation for proper drive jumper settings and cable orientation.)
7Close the case as described in Chapter 3.
8Reconnect the power and modem cords, then turn on the system.
Hard drives | 51 |