Contents
0DLQWHQDQFH0DQXDO
60+ Operation and Maintenance Manual
6HFWLRQ
Two-Pass Mount and Laminate Hot and Cold
Push either Twist pressed
Safety
DXWLRQin an emergencyDUQLQJ. /DEHO/RFDWLRQV
Inside cabinet
Decal Meaning
Blank
These instructions so that you can insure that your new
Moved and installed
60+ Laminator is properly and securely unpacked
Is there ample room for the laminator?
Installation
Alternative Power Configurations
To uncrate the laminator
Tools required
Fork Lift Blade Locations
Setup Procedure
Hex wrench Adjustable wrench
To level the laminator
Startup Checklist
Installation
Operation
Roll Pressure Display Displays the per
Power ON/OFF Indicator Indicates
HE8S
To your machine and is not recommended or
Covered under our warranty
Pull roll clutch tension adjustment
When the machine is not in use, the pull rolls
Must be raised to prevent damaging the rolls
3URFHVV &RQWURO&KDUWV
See process chart
Heat-activated laminating using mounting board with
Lay the print on the board. Using a tack iron, tack
Feed the work into the nip with the leading edge tight
Entering the nip evenly from side to side. For thin
3URFHGXUH3DVV
352&66&21752/&+$57
Identification Diagram
352&66&21752/,$*5$0
352&66&21752/,$*5$0
352&66&21752/&+$57
One Pass Mounting
352&66&21752/,$*5$0
352&66&21752/&+$57
One Pass Mount and Laminate
Process One Pass Mount & Laminate Date
352&66&21752/,$*5$0
352&66&21752/&+$57
Encapsulation
Product 3 Mil Gloss/3Mil Gloss
352&66&21752/,$*5$0
352&66&21752/&+$57
Cold Overlamination
Process Cold Overlamination Date
352&66&21752/,$*5$0$
352&66&21752/&+$57$
Cold Mount and Laminate First Pass
Process Cold Mount & Laminate First Pass Date
352&66&21752/,$*5$0%
352&66&21752/&+$57%
Cold Mount and Laminate Second Pass
Product Process Cold Mount & Laminate Second Pass
352&66&21752/,$*5$0$
352&66&21752/&+$57$
Mount and Hot Overlaminate First Pass
Product
352&66&21752/,$*5$0%
352&66&21752/&+$57%
Mount and Hot Overlaminate Second Pass
Product Process Mount & Hot Overlaminate Second Pass
Operation
Age Inspect the footswitch cord for dam Adjust the nip
Clean the rolls
GBC Pro-Tech laminators require minimal mainte
Adhesive coated board
To clean the cabinet and covers
To clean beads of adhesive, dust and dirt from the rolls
Hex wrench ¾ hex wrench
$GMXVWLQJWKH1LS
Hex wrench Screwdriver
To adjust the chain tension
1844 202 440 or fax +44 0 1844 202
Xeulfdwlrq
2XWSXW7URXEOHVKRRWLQJ*XLGH
Unauthorized customer alterations will void this Warranty
This warranty specifically does not cover
Faces
Customer’s sole and exclusive remedy under this
Warranty
Part Description
Quantity
Specifications
Process control charts
Accessory pack Laminating rolls Adjusting Laminating speeds
Pull roll 5clutch adjustment Grease fittings
Resetting the laminator 1-1,3-1
Index
