GBC 930-028 manual These instructions so that you can insure that your new, Moved and installed

6HFWLRQ ￿￿,QVWDOODWLRQ	Installation
-60+ Operation and Maintenance Manual
GBC Pro-Tech is committed to a program of ongoing	CAUTION
product improvement. As a result, we are providing	Do not locate the laminator where air is blowing
these instructions so that you can insure that your new	directly on the machine. The air flow can cool the
F-60+ Laminator is properly and securely unpacked,	rolls unevenly and result in poor quality output.
moved and installed.

Before a F-60+ Laminator can be installed, there are a few requirements that must be met. Make certain that each of the requirements listed in the following prein- stallation checklist are met before beginning installa- tion.

3UHLQVWDOODWLRQ&KHFNOLVWCAUTION

Failure to follow the preinstallation checklist can

result in damage to the laminator.

❏Are doorways and hallways wide enough for the laminator to be moved to the installation site?

❏Is there ample room for the laminator?

A work area must be established that allows for operation in both the front and the rear of the machine and provides space for efficient material flow. Figure 2-1 shows a typical machine area lay- out.

❏Is the environment appropriate for the laminator? The laminator requires a clean, dust and vapor free environment to operate properly, such as an air conditioned office area with forced 10% make up air. However, the laminator must not be located where there is air blowing directly on it. Major fluctuation in temperature and humidity are to be avoided.

WARNING

The operating environment must be free of dust,

flammable liquids and vapors. You can be injured by inhaling chemical vapors. Vapor build up or stored flammable liquids can cause a fire. Excessive dust can damage the laminator.

❏Is there an appropriate power outlet available or has a certified electrician been contacted to wire the laminator directly?

The laminator requires 60A single phase, 220/230/ 240 VAC service or, in Europe, 3 Phase, 240 VAC with 30 Amps per phase. See Figure 2-2 for alter- native power hookup configurations.

WARNING

Do not attempt to defeat the grounding feature of the ground plug on the laminator. You can be severely shocked, electrocuted or cause a fire. The three prong plug fits only into a grounding- type power outlet. If you are unable to insert the plug into the existing outlet, contact a qualified electrician to replace the obsolete outlet.

WARNING

Do not use an extension cord on this laminator. You can be severely shocked, electrocuted or cause a fire. If you need a longer cable contact a qualified electrician.

WARNING

Do not operate the laminator if the power cord is damaged or frayed. You can be severely shocked, electrocuted or cause a fire. Contact a qualified electrician to replace the cord.

WARNING

Do not allow anything to rest on the power cord. Do not locate the cord where people can walk on it. You or others can be severely shocked, electrocuted or cause a fire.

© GBC Pro-Tech 1999 April 2-1