GBC 930-028 When the machine is not in use, the pull rolls, Pull roll clutch tension adjustment

+HDWLQJ		Operation
F-60+ Operation and Maintenance Manual
Use the following instructions when heating one or	3DSHU7LSV	CAUTION
both of the laminating rolls. The procedure is the same
	When the machine is not in use, the pull rolls
for the top and bottom heaters.
	must be raised to prevent damaging the rolls.

1.Set the heater switch to ON.

2.Adjust the temperature controller for the desired operating temperature using the temperature con-

	troller push buttons.	Always feed prints perpendicular to the laminating
		rolls.
.	When heating the rolls, keep the top roll down and
		1.	Lock core support to middle of the shaft. Lock two
	turning at a moderate speed to prevent uneven
			core chucks on shaft ends, located to support mate-
	heating.
			rial a few inches from ends of the roll.
4.	It will take approximately 30 minutes for the lami-
		☞ Note
	nating roll(s) to reach operating temperature. When
	the preset operating temperature has been reached,	Paper unwind may require two evenly spaced core sup-
3XOO5ROOthe machine&OXWFKis ready$toGMXVWPHQWuse.		ports if wide rolls of prints (paper) are used.
		2.	Place the roll on the unwind shaft.

The F-60+ Laminator has an adjustable clutch for the pull rolls on the machine, allowing you to adjust the amount that the film is tensioned as it leaves the main rolls and is cooled. The clutch adjustment is made by using the knob on the drive side of the machine.

Pull roll clutch tension adjustment:

Turning the knob clockwise increases tension.

Turning the knob counterclockwise decreases tension.

3.Carefully close the unwind shaft, holding the roll away from the hinge.

4.When the shaft is in the saddle, push in the locking pin.

5.Center the roll of material.

6.Web and tension film per process control chart and diagram.

© GBC Pro-Tech 1999 April 3-5