GBC 930-028 manual Lay the print on the board. Using a tack iron, tack

3URFHGXUH		(QFDSVXODWLRQ		Operation
-60+ Operation and Maintenance Manual
1.	Lay the print on the board. Using a tack iron, tack	6HWXS
	the leading edge of the print down onto the board
	so it is held in place.	1. See process chart 3-3.
2.	Put a piece of contact/release paper over the print	2.	Laminating Roll Pressure: 30-40%.
	and board. Otherwise, adhesive will be applied to	.	Speed: 0-6 fpm (0-180 cpm).
	the laminating roll, which can cause damage and
		4. Upper Laminator Roll Heat: 230 °F (110 °C).
	the ink from electrostatic prints will be deposited
	on the roll.	5. Lower Laminator Roll Heat: 32 °F (0 °C).
3.0RXQWLQJFeed the print/board￿/DPLQDWLQJpackage through the nip.		6.	Cooling: Optional.
		. Use of the rear wind-up roll for the finished mate-
The following procedure is for one-step mounting and		3URFHGXUHrial is optional. It is a good procedure for long runs.
heat-activated laminating using mounting board with
one6HWXSadhesive side.		Feed the work into the nip with the leading edge tight
3URFHGXUH		and entering the nip evenly from side to side. For thin
1.	See process chart 3-2.	paper from electrostatic printers in roll form it is best to
		fold over the leading edge approximately 6 inches to
2.	Mount the film and web as shown in diagram	createDQG&ROG7ZR￿a3DVV0RXQWsquare￿leading edgeDQG/DPLQDWH.			￿+RW
	3-2.
.	Set the nip for the substrate thickness by raising or
	lowering the upper main roll using the hand crank.	There are several approaches to the mount/laminate
4.	Laminator Roll Pressure: 10–30%.
		task. It can be accomplished with either hot or cold
5.	Speed: fpm (1 m/min).
		laminate film on the top. Also, the second pass for
6.	Upper Laminator Roll Heat: 240 °F (115 °C).	mounting can be done by feeding from either the front
		or6HWXSback of the laminator.
1.	Lay the print on the board. Using a tack iron, tack	See process charts -4, 3-5A & B, and 3-6A & B for
	the leading edge of the print down onto the board
		film3URFHGXUHmounting￿instructions￿and machine adjustments.
	so it is held in place.
2.	Feed the print/board package through the nip.		3DVV

1. Run the print through to apply adhesive and lami- nate.

2. Trim to slightly larger than the desired finished size.

© GBC Pro-Tech 1999 April 3-7