GBC 930-028 manual Power ON/OFF Indicator Indicates, Roll Pressure Display Displays the per

2SHUDWRUOperation &RQWUROV

The operator controls for the F-60+ Laminator are located on the front and rear of the unit, to the right of the operator position. The names and functions of these )URQW&RQWUROcontrols are as follows:3DQHO

F-60+ Operation and Maintenance Manual

6.UPPER ROLL HEAT ON/OFF – Turns the heater controller for the upper main roll on or off.

7.LOWER ROLL HEATER CONTROLLER– Provides a readout of the temperature of the lower roll and the set-point for the desired temperature.

8.LOWER ROLL HEAT ON/OFF – Turns the heater controller for the lower main roll on or off.

9.COOLING FAN ON/OFF – Turns the cooling fan on or off.

	100
	90
	80
	70
1	60	CAL 3200
	50
Roll	40
Pressure	30
Display	20
	10

CAL 3200

5

6

7

8

Upper Roll Heater Controller

Upper Roll Heat

ON/OFF

Lower Roll Heater Controller

Lower Roll Heat

ON/OFF

10. POWER ON/OFF INDICATOR – Indicates

when the main power is being applied to the

)RRWVZLWFKmachine. 2SHUDWLRQ

The footswitch can be used for feeding materials through the main rolls (forward mode). Material speed is controlled by the Control Panel Speed Adjustment

RUN/STOP/	2
EYE RESET
Motion Control	3
FORWARD/
REVERSE				5 6
		4		7
		3		8
Speed	4	2	2	9
Adjustment		1		10

9 Cooling Fan ON/OFF

10

Power On/Off Indicator

knob, resulting in constant speed operation when the footswitch is pressed. The footswitch can also be used for feeding materials through the pull rolls (reverse mode). Material speed is controlled by the footswitch, which operates much like the accelerator on an auto- mobile.

Figure 3-4: Front Control Panel

1.	ROLL PRESSURE DISPLAY - Displays the per-
	centage of force pushing the main laminating roll
	down.
2.	RUN/STOP/EYE RESET – Turns the drive sys-
	tem on or off and resets the photoelectric eyes
	when in automatic forward mode. The photoelec-
	tric eyes do not function in reverse mode.
3.	MOTION CONTROL FORWARD/REVERSE -
	Controls the direction of the drive system, forward,

CAUTION

When the footswitch is used the photoelectric eye guarding the main rolls is turned off. Release the footswitch to stop the machine rolls.

	reverse, or stop.
4.	SPEED ADJUSTMENT – Adjusts the speed of
	the machine from zero to the maximum as the con-
	trol is turned clockwise. (Turtle is slow, rabbit is
	fast.)
5.	UPPER ROLL HEATER CONTROLLER –
	Provides a readout of the temperature of the upper
	roll and the set-point for the desired temperature.

☞NOTE

Feed

Material

Into Nip

Remove

Guard

	-6	0	+	™
F

-TECH PRO

Press Footswitch (variable speed)

The bottom roll heater controller must be turned on before the top roll heater controller will energize the top heater.

Figure 3-5: Using the Footswitch

3-2 © GBC Pro-Tech 1999 April