GE 0150-0193G manual RS485 Connector, RJ-45 Pin Configuration For RS485 Port, Ethernet Port

Pin 1: Not Used.

Pin 2: Audio Out.

Pin 3: Ground.

Pin 4: Audio In.

Pin 5: Ground.

Pin 6: Not Used.

Pin 7: Ground.

Pin 8: Not Used.

Pin 9: Ground.

GND: Ground.

RS485 Connector

Shields are grounded at one end, preferably at the DVMRe Triplex.

See section 3.17 for information about configuring the RS485 network address settings in the menu system.

1	6
2	7
3	8
4	9

5 GND

Accessory PCB

Wire Type: #24 AWG, twisted pair with shield (2-wire)

Connector Type: RJ-45

Max. Cable Length: 3200 feet / 1000 meters

RJ-45 Pin Configuration For RS485 Port

Pin	Use		Pin	Use
						1 2 3 4 5 6 7 8
1	Ground (Shield)	5		Not Connected
2	Not Connected	6		Network -VE
3	Network +VE	7		Ground (Shield)
4	Not Connected	8		Not Connected	RJ-45 socket on
						back panel.

Ethernet Port

The cable connection configuration depends on your network configuration:

∙For a DVMRe Triplex that connects directly to a Hub or Switch, use a straight through connection.

∙For a DVMRe Triplex that connects directly to a PC, use a cross over connection.

Consult with your MIS personnel for the specific type of configuration. See section 3.17 for information about configuring the ethernet settings in the menu system.

Wire Type: Cat 5

Connector Type: RJ-45

Max. Cable Length: 100 meters / 328 ft.

Min. Cable Length: 6 feet / 1.8 meters

Hub Wiring Configuration: Straight Through

PC Wiring Configuration: Cross Over

0150-0193G 13 DVMRe Triplex