2
About the dryer control panel.

Dry Cycles

The dry cycle controls the cycle time for the drying process. The chart below will help you match
the dry setting with the loads.
Sensor Cycles
COTTONS For cottons and most linens.
NORMAL/ For loads consisting of cottons and poly-blends.
MIXEDLOAD
WRINKLE FREE For wrinkle-free/easy care and permanent press items.
ACTIVEWEAR Clothing worn for active sports exercise and some casual wear. Fabrics include new
technology finishes and stretch fibers such as Spandex.
DELICATES For lingerie and special-care fabrics.
SPEEDDRY For small loads that are needed in a hurry, such as sports or school uniforms. Can also be
used if the previous cycle left some items damp, such as collars or waistbands.
Timed Dry Cycles
STEAM For slightly wrinkled dry garments. Significantly reduces wrinkles on 1–5 garments.
REFRESH Selecting a higher number of garments for the cycle (e.g., selecting 5-garment load
for a 1-garment load) may result in excessive wetting of clothes. After the SteamRefresh
Cycle, the unit will beep and display “Garments Ready” and “0:00.” If the unit is not turned
off or if the door is not opened, the dryer will continue to tumble for 30 minutes. At the end
of 30 minutes, it will display “0:00” and “Cycle Complete.”
A single extremely light fabric item may need to have an additional item included
in the steam refresh cycle to achieve optimum results.
STEAM For use with larger loads than STEAMREFRESH. Ideal for loads left in dryer for an extended
DEWRINKLE time. Selecting a larger cycle than needed (e.g., selecting Large Load for a half-full dryer)
may result in excessive wetting of clothes.
WARMUP Provides 10 minutes of warming time to warm up clothes.
My Cycle (on some models)
MY CYCLE Press to use, create or modify custom dry cycles.

Timed Dry

Use to set your own dry time. TIMEDDRY is also recommended for small loads.
To use TIMEDDRY:
1. Turn dry cycle dial to TIMEDDRY.
2. Select the drying time by pressing the ▲and ▼buttons. You can increase the time in 10-minute
increments up to 21⁄2hours.
3. Select the DRYTEMP.
4. Close the door.
5. Press START/PAUSE.

Sensor Dry Level

The sensor continuously monitors the amount of moisture in the load. When the moisture in your
clothes reaches your selected dry level, the dryer will stop.
EXTRA DRY Use for heavy-duty fabrics or items that should be very dry, such as towels.
MOREDRY Use for heavy or mixed type of fabrics.
DRY Use for normal dryness level suitable for most loads. This is the preferred cycle
for energy saving.
LESSDRY Use for lighter fabric (ideal for ironing).
DAMP For leaving items partially damp.
3
4
6
Operating Instructions Safety Instructions
Consumer Support Troubleshooting Tips