Graco 334135B Shutdown, Relieve pressure. See Pressure Relief Procedure

Operation

Shutdown

If the machine is to remain idle for an extended period of time, perform the following steps.

1.If installed, remove static mixer from the end of the dispense valve.

2.Place a container below the dispense valve and activate a small shot to flush mixed material out of the valve.

3.Relieve pressure. See Pressure Relief Procedure, page 33.

4.With a clean rag and cotton swabs, clean the end of the dispense valve.

5.Install the nightcap on the dispense valve. Refer to MD2 Valve, Instructions manual for part information.

34 334135B