Graco 334135B important safety instructions Install Upgrade Token, Remove Access Panel

Maintenance

Install Upgrade Token

This procedure applies to the Local Control Module (LCM).

1.Disconnect power to the module.

2.Remove token access panel.

FIG. 10: Remove Access Panel

3. Press firmly the token into the slot.

NOTE: There is no preferred orientation of the token.

4.Restore power to the module. The red LED will flash rapidly to signal that software is loading. When the red LED stops flashing, the software is done load- ing.

5.Disconnect the power to the module.

6.Remove the token.

7.Replace the token access panel.

8.Restore power to the module.

9.Verify new software versions on the Setup Screen Password Set/Clear Screen screen. Refer to PKE 2903 found at www.graco.com for the latest software version by utilizing the search box.

36 334135B