Graco 3A2495C important safety instructions Spray Tip Selection Chart, AEM Fine Finish Spray Tips

Spray Tip Selection Chart

Spray Tip Selection Chart

AEM Fine Finish Spray Tips

Recommended for high finish quality applications at low and medium pressures. Order desired tip, Part No. AEMxxx, where xxx = 3–digit number from the matrix below.

Orifice	Fluid Output			Maximum Pattern Width at 12 in.					(305 mm)
Size	fl oz/min (l/min)					in.	(mm)
in.	at 600	at 1000	2–4	4–6	6-8	8-10		10-12	12-14	14-16	16-18
(mm)	psi (4.1	psi (7.0	(50–	(100–	(150-	(200-		(250-	(300-	(350-	(400-
	MPa,	MPa,	100)	150)	200)	250)		300)	350)	400)	450)
	41 bar)	70 bar)				Spray Tip
† 0.007	4.0	5.2	107	207	307
(0.178)	(0.1)	(0.15)
† 0.009	7.0	9.1		209	309	409		509	609
(0.229)	(0.2)	(0.27)
† 0.011	10.0	13.0		211	311	411	511		611	711
(0.279)	(0.3)	(0.4)
0.013	13.0	16.9		213	313	413	513		613	713	813
(0.330)	(0.4)	(0.5)
0.015	17.0	22.0		215	315	415	515		615	715	815
(0.381)	(0.5)	(0.7)
0.017	22.0	28.5		217	317	417	517		617	717
(0.432)	(0.7)	(0.85)
0.019	28.0	36.3			319	419	519		619	719
(0.483)	(0.8)	(1.09)
0.021	35.0	45.4				421	521		621	721	821
(0.533)	(1.0)	(1.36)
0.023	40.0	51.9				423	523		623	723	823
(0.584)	(1.2)	(1.56)
0.025	50.0	64.8				425	525		625	725	825
(0.635)	(1.5)	(1.94)
0.029	68.0	88.2									829
(0.736)	(1.9)	(2.65)
0.031	78.0	101.1				431			631		831
(0.787)	(2.2)	(3.03)
0.033	88.0	114.1									833
(0.838)	(2.5)	(3.42)
0.037	108.0	140.0								737
(0.939)	(3.1)	(4.20)
0.039	118.0	153.0						539
(0.990)	(3.4)	(4.59)

* Tips are tested in water.

Fluid output (Q) at other pressures (P) can be calculated by this formula: Q = (0.041) (QT) where QT = fluid output (fl oz/min) at 600 psi from the above table for the selected orifice size.

† These tip sizes include a 150 mesh filter.

62 3A2495C