Grizzly G0634Z manual Test Run, To test run the machine

Test Run

Once the assembly is complete, test run your machine to make sure it runs properly and is ready for regular operation. The test run consists of verifying the following: 1) The motor powers up and runs smoothly and without vibration and 2) the stop button safety feature works correctly.

If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review Troubleshooting on Page 37.

If you cannot find a remedy, contact our Tech Support at (570) 546-9663 for assistance.

Before starting the jointer/planer, make sure you have performed the preceding assem- bly and adjustment instructions, and you have read through the rest of the manual and are familiar with the various functions and safety features on this machine. Failure to follow this warning could result in seri- ous personal injury or even death!

To test run the machine:

1.Make sure you understand the safety instruc- tions at the beginning of the manual and that the machine is setup properly.

2.Make sure all tools and objects used during setup are cleared away from the machine.

3.Make sure the jointer tables are folded down and locked in place (see Page 25).

4.Connect the machine to the power source.

5.Push the EMERGENCY OFF button in, then twist it clockwise so it pops out. See Figure 1, Page 7 for location of the EMERGENCY OFF button. When the OFF button pops out, the switch is reset and ready for operation (see Figure 17).

-20-

���	�
�
��������	������������
���������	����������

���

Figure 17. Resetting the Emergency Off switch.

6.Verify that the machine is operating correctly by pushing the green ON button.

—When operating correctly, the machine runs smoothly with little or no vibration or rubbing noises.

—Investigate and correct strange or unusual noises or vibrations before operating the machine further. Always disconnect the machine from power when investigating or correcting potential problems.

7.Press the EMERGENCY OFF button to stop the machine.

8.WITHOUT resetting the switch, press the ON button. The machine should not start.

—If the machine does not start, the EMERGENCY OFF button safety feature is working correctly.

—If the machine does start (with the EMERGENCY OFF button pushed in), immediately disconnect power to the machine. The EMERGENCY OFF button safety feature is not working correctly. This safety feature must work properly before proceeding with regular operations. Call Tech Support for help.

9.Press the ON button, then immediately press the OFF button on the magnetic box (Figure 1, Page 7).

—If the machine turns off, the OFF button is working correctly. The Test Run is com- plete.

—If the machine does not stop, disconnect power to the machine. The OFF button is not working correctly. This feature must work properly before proceeding with regu- lar operations. Call Tech Support for help.

G0633/G0634 Jointer/Planer Combo Machine