| ���������� |
���������� | ���������� |
| ������ |
����� | ����� |
| ������ |
��������� 
Figure 69. Pulleys properly aligned. V-belts are
parallel and coplaner.
—If the pulleys are aligned, then no adjust- ments are necessary.
—If the pulleys are NOT aligned, perform Steps 3 & 4.
3.Remove the V-belts (see Page 34), loosen the set screws on the end of the cutterhead pulley, and align the cutterhead pulley with the motor pulley.
4.Tighten the set screws, replace the V-belts, and repeat Step 2.
5.Reinstall the V-belt cover, fence bracket and fence assembly.
Setting Fence Stops
The fence stops simplify the task of adjusting the fence to 45˚ and 90˚.
Tools Needed | Qty |
45° Square | 1 |
90° Square | 1 |
Sliding Bevel | 1 |
Wrench 10mm | 1 |
To set the 90˚ fence stop: |
|
1.Loosen the lock nut on the 90° fence stop bolt shown in Figure 70, and loosen the fence tilt lock.
2.Place a 90° square against the table and fence, and adust the stop bolt, so the fence is set exactly at 90°.
Lock Nut
| 90˚Stop Bolt |
|
|
| Figure 70. Adjusting fence to 90˚. |
3. | Tighten the lock nut. |
4. | Adjust the indicator (if necessary) to 0° to |
| calibrate the fence tilt scale. |
G0633/G0634 Jointer/Planer Combo Machine |
