Recommended

Adjustments

For your convenience, the adjustments listed below have been performed at the factory and no further setup is required to operate your machine.

However, because of the many variables involved with shipping and storage, some of these adjust- ments may need to be repeated to ensure opti- mum cutting results. Keep this in mind as you start to use your new jointer/planer.

Step-by-step instructions for these adjust- ments can be found in SECTION 7: SERVICE ADJUSTMENTS.

1.Jointer Table Parallelism (Page 39)

2.Depth Scale Calibration (Page 46)

3.Fence Stop Accuracy (Page 47)

4.Planer Table Parallelism (Page 50)

5.Feed Roller Spring Tension (Page 51)

G0633/G0634 Jointer/Planer Combo Machine

Tighten V-Belts

The final step in the setup process must be done after approximately 16 hours of operation. During this first 16 hours, the V-belts will stretch and seat into the pulley grooves. After this 16 hours, you must retension the V-belts to avoid slippage and burn out. Refer to Page 34 when you are ready to perform this important adjustment.

Note: Pulleys and belts can get hot. This is a nor- mal condition. Allow them to cool before making adjustments.

A small amount of black belt dust at the bottom of the belt housing is normal during the life of the machine and does not indicate premature belt failure is in progress.

-21-

Page 39
Image 39
Grizzly G0634Z manual Recommended Adjustments, Tighten V-Belts