9 Appliance Preparation
A. Top Vent
CAUTION! Risk of Cuts/Abrasions/Flying Debris. Wear protective gloves and safety glasses during installation. Sheet metal edges are sharp.
NOTICE: Once appliance is set up for top or rear venting, it CANNOT be changed at a later time.
Figure 9.1
•Remove the cover plate by removing the four screws holding it to the top of the appliance. Remove and discard the cover plate.
Figure 9.2
•Remove the center insulation plug.
Figure 9.4
•Fold the center parts of the retaining band up and use to remove the vent cap.
Figure 9.5
•Discard the vent cap, remove and discard the insulation basket. Note: Once the vent cap has been removed it cannot be reattached.
Figure 9.3
•Cut the metal retaining band and fold the sides out.
Figure 9.6
•Attach the first vent section. It will snap into place.
Proceed to Section 10. C.
36 | Heatilator • Novus NDV Series • |
