Heat & Glo LifeStyle 2137-900 owner manual Installation of Non-combustible Facing Material

B. Installation of Non-combustible Facing Material

The non-combustible assembly is located on the left side of appliance.

CAUTION

Handle with care.

• Non-combustible material may be damaged if dropped.

•Remove and save two screws from upper bracket.

•Remove non-combustible pieces.

•Remove and save two screws from lower bracket.

•Discard brackets.

•Replace screws in holes where brackets were attached to appliance.

•Attach non-combustible panel to appliance and framing with supplied screws. See Figures 7.6, 7.7 and 7.8.

WARNING

Fire Risk.

•Follow these instructions exactly.

•Facing materials must be installed properly to prevent fire.

• No materials may be substituted without authorization by Hearth & Home Technologies.

•Use regular sheetrock screws in non-shaded areas.

•Use a wet or dry towel or soft brush to remove dust or dirt from facing material.

•Apply a non-combustible adhesive to attach tile, stone or other non-combustible finishing materials per manufacturer’s instructions.

NON-COMBUSTIBLE

ZONE

37.9"

31.7"

Figure 7.6 Complete Installation of Non-combustible Facing

Material

	NON-COMBUSTIBLE FACING MATERIAL
	SUPPLIED LEFT SIDE OF APPLIANCE
Figure 7.7 Attaching Non-combustible Facing Material
20	Heat & Glo • Soho24B • 2137-900 Rev. P • 8/12