3V TRANSFORMER
ON/OFF
WALL SWITCH
IGNITION |
|
MODULE |
|
(3V) |
|
VALVE | LOW VOLTAGE |
| SEE NOTE 1 |
NEUTRAL | GROUND REMOTE |
| CONTROL HOT |
BLACK WIRE CAN BE |
|
PLUGGED INTO ANY |
|
OF #1 - #5 LOCATIONS |
|
ON THE HOT SIDE |
|
WHITE WIRE CAN BE
PLUGGED INTO ANY
OF#1 - #5 LOCATIONS
ON THE NEUTRAL SIDE
TRANSFORMER
3 VAC
IGNITION MODULE 3 VAC
ORG
WHT
| GROUND TO |
| FIREPLACE |
| CHASSIS* |
BLK | ORG |
| |
RED | BRN |
BRN |
VALVE
INTERMITTENT
PILOT IGNITOR
GRN
THERMOSTAT
WIRE
ASSEMBLY
REMOTE 
JUMPER WIRE
Figure 10.1 IntelliFire Pilot Ignition (IPI) Wiring Diagram - Standard Method. Note: Appliance will not operate unless properly grounded.
D. Junction Box Installation
If the box is being wired from the OUTSIDE of the appliance:
•Remove the cover plate located on the outer shell - right side (see Figure 10.2).
•Install the supplied Romex™ connector in the cover plate.
•Feed the necessary length of wire through the connector.
•Make all necessary wire connections and reattach the cover plate to the outer shell.
If the box is being wired from the INSIDE of the appliance:
•Remove the screw attaching the junction box/ receptacle to the outer shell, rotate the junction box inward to disengage it from the outer shell (see Figure 10.2).
•Pull the electrical wires from outside the appliance through this opening into the valve compartment.
| Romex |
| Connector |
| 14/2WG |
| Cover Plate |
| outside firebox |
WHT |
|
BLK |
|
WHT |
|
BLK | Copper |
| |
GRN wire | ground attached |
to GRN screw with | |
inside box | GRN wire |
| NOTE: Do NOT wire |
| 110VAC to wall switch. |
Figure 10.2 Junction Box Detail
•Feed the necessary length of wire through the connector.
•Make all necessary wire connections to the junction box/ receptacle and reassemble the junction box/receptacle to the
outer shell.
Heat & Glo • Soho24B • | 31 |
