Heat & Glo LifeStyle 2137-900 Stone Placement Soho24B, D. Positioning Stones, Jig Pilot Shield

D. Positioning Stones

For proper performance and safety, it is critical that the Black Onyx stones are set up in accordance with these instructions.

Stone Placement: Soho24B

WARNING! Choking Hazard! Keep stones out of reach of children.

BURNER AREA

Figure 12.1.

As you are positioning the stones, make sure that no stones are in the cross-hatched area shown between the two arrows above. This is to ensure proper lighting and avoid interference with the pilot flame.

WARNING

Delayed Ignition Risk

•Place stones according to instructions.

•Do NOT place stones in area in front of pilot shield.

•Do NOT place stones in a position that they may fall into area in front of pilot shield.

•Do NOT use any media other than the stones supplied with this fireplace.

Fireplace will not function properly.

Delayed ignition may occur.

JIG

PILOT SHIELD

Figure 2.

Step 1. The included stone placement jig MUST be used any time stones are placed on the burner to ensure that none end up in the cross-hatched area noted in Figure 1.

Figure 12.3.

Step 2. The stone placement jig is shipped in its proper position. Remove the two screws securing the jig, making sure the jig stays in the proper position. See Figure 3.

Figure 12.4.

Step 3. Place a single layer of stones over the burner area inside of the tabs surrounding the burner and behind the pilot shield.

Figure 12.5.

Step 4. Place the remaining stones over the basepan taking care not to add more stones to the burner area.

2137-936C

Heat & Glo • Soho24B • 2137-900 Rev. P • 8/12 35