Heat & Glo LifeStyle LUX60 Light Glass Replacement/Cleaning, LED Light Bar Replacement

Light Glass Replacement/Cleaning

Frequency: Annually

By: Qualified Service Technician

Tools needed: Protective gloves

•Disconnect power to fireplace.

•Remove the “L” plates and inner surround frame (see surround install). This will make the valve compartment and glass accessible.

CAUTION! The surround kit is heavy. We recommend two installers to move the frames.

•Loosen the two thumb screws on the glass frame above the LED light bar. See Figure 3.4.

•Slide the frame forward and out. Unplug LED light bar and remove glass frame assembly.

•Ensure glass frame is clean of debris or replace if needed..

Thumb Screws

Figure 3.4 Loosen Glass Frame

•Reinstall glass frame. The frame must be hooked on both shoulder screws on the firebox bottom. See Figure 3.5.

•Slide glass and gasket into glass frame ensuring the glass is centered into inner frame.

•Install both thumb screws through glass frame and into firebox bottom.

•Ensure the glass is fully seated and that the thumb screws are tight.

•Plug in light bar.

•Reinstall “L” plates.

Shoulder

ScrewSlot

Glass & Gasket

Figure 3.5 Reinstall Glass Frame

LED Light Bar Replacement

Frequency: As needed

By: Qualified Service Technician

Tools needed: Protective gloves, phillips screwdriver

•Disconnect power to fireplace.

•Remove the “L” plates and inner surround frame (see surround install). This will make the valve compartment and light bar accessible.

•Remove the two screws securing the light bar on the front of the bracket.

•Release the 4-pin connector jumper wire between the lights to remove the light strip.

•Install new light bar (shown in Fig. 3.6).

Figure 3.6 Light Bar

Heat & Glo • LUX60 • 4062-116 • Rev. G • 4/11 17