Heat & Glo LifeStyle LUX60 owner manual Electrical Information, A. Wiring Requirements

13 Electrical Information

A. Wiring Requirements

NOTICE: This appliance must be electrically wired and grounded in accordance with local codes or, in the absence of local codes, with National Electric Code ANSI/NFPA 70-latest edition or the Canadian Electric

Code CSA C22.1.

•Wire the appliance junction box to 110-120 VAC. This is required for use of optional accessories.

•A 110-120 VAC circuit for this product must be protected with ground-fault circuit-interrupter protection, in compliance with the applicable electrical codes, when it is installed in locations such as in bathrooms or near sinks.

•Low voltage and 110 VAC voltage cannot be shared within the same wall box.

WARNING! Risk of Shock or Explosion! DO NOT wire

110V to the valve or to the appliance wall switch. Incorrect wiring will damage controls.

B. Electrical Service and Repair

WARNING! Risk of Shock! Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

WARNING! Risk of Shock! Replace damaged wire with type 105° C rated wire. Wire must have high temperature insulation.

			ORANGE
	WHITE
			F			BLACK
			M
			F
			M
				POWER
				SUPPLY
	GREEN		BROWN		ORANGE
ORANGE
GROUND
BLACK
IPI
VALVE
		1
	GREEN	2
	IPI	3		BROWN
		4			LUX
	MODULE	5		BROWN
		6		RED	CONTROL
		7			MODULE
		8
			3V DC	BLACK
FLAME
SOLENOID
					LEARN	BLACKWires
					BUTTON
					4BLACKWires
						4
					4 BLACK Wires
Figure 13.1 Wiring Diagram
		Heat & Glo • LUX60 • 4062-116 • Rev. G • 4/11				45