Matching Security Codes
It may be necessary to program the control module to the security code of the remote upon initial use, if batteries are replaced, or if a replacement control module is pur- chased from your dealer. To program the control module:
•Push the LEARN button located next to the four pin LED connector on the control module. (Refer to Figure 13.1 for location of button.)
•The LED located between the control module connectors will flash.
•Then press the power button on the remote.
The LED will turn OFF to indicate the remote’s code has been programmed into the control module. When an existing receiver is matched to a new transmitter, the new security control module will overwrite the old one.
NOTE: If you are unsuccessful in matching the security code on the first attempt, wait
System Operation
•POWER BUTTON (bottom button)
-Pressing the POWER button will energize the LED lights circuit at the last stored speed and/or paused color and light the burner on high. The burner will always light in the high flame position.
-Pressing the POWER button again will turn OFF the LED lights and BURNER.
•SPEED BUTTON (second from bottom)
-Each press of the SPEED button will sequence the LED lights through four fixed speeds and an OFF mode.
-The color fade speed will be stored ten seconds after each speed change.
-If the POWER is OFF – The SPEED button will have no effect.
•FLAME BUTTON (second from top)
-Each press of the FLAME button will sequence the BURNER from HIGH flame to LOW flame to OFF to HIGH flame.
-Use this feature to provide LUX illumination without heat.
-If the POWER is OFF – The FLAME button will have NO effect.
•PAUSE BUTTON (top button)
-Each press of the PAUSE button will toggle the LED lights color change from fixed color to fading color and back to fixed color.
-The color will be stored ten seconds after each pause.
H. Before Lighting Fireplace
Before operating this fireplace for the first time, have a qualified service technician:
•Verify all shipping materials have been removed from inside and/or underneath the firebox.
•Review proper placement of decorative steel log assembly, glass rock and/or other decorative materials.
•Check the wiring.
•Check the air shutter adjustment.
•Ensure that there are no gas leaks.
•Ensure that the glass is sealed and in the proper position and that the integral barrier is in place.
WARNING! Risk of Fire or Asphyxiation! DO NOT oper-
ate fireplace with fixed glass assembly removed.
PAUSE BUTTON
FLAME BUTTON
SPEED BUTTON
POWER BUTTON
Remote
Heat & Glo • LUX60 • | 11 |
