Travelstar 5K160 (SATA) Hard Disk Drive Specification
7
CRC
6
UNC
5
0
4
IDNF
3
0
2
ABRT
1
TK0NF
0
AMNF
Table 27. Error Register
This register contains status from the last command executed by the device, or a diagnostic code.
At the completion of any command except Execute Device Diagnostic, the contents of this register are valid always even if ERR=0 in the Status Register.
Following a power on, a reset, or completion of an Execute Device Diagnostic command, this register contains a diagnostic code. See “Diagnostic Codes” on Page 5 for the definition.
Bit Definitions |
|
ICRCE (CRC) | Interface CRC Error. CRC=1 indicates a CRC error has occurred on the data bus during a |
UNC | |
Uncorrectable Data Error. UNC=1 indicates an uncorrectable data error has been | |
IDNF (IDN) | encountered. |
ID Not Found. IDN=1 indicates the requested sector’s ID field could not be found. | |
ABRT (ABT) | Aborted Command. ABT=1 indicates the requested command has been aborted due to a |
TK0NF (T0N) | device status error or an invalid parameter in an output register. |
Track 0 Not Found. T0N=1 indicates track 0 was not found during a Recalibrate command. | |
AMNF (AMN) | Address Mark Not Found. AMN=1 indicates the data address mark has not been found after |
| finding the correct ID field for the requested sector. |
| This bit is obsolete. |
11.6 Features Register
This register is command specific. This is used with the Set Features command, S.M.A.R.T. Function Set command and Format Unit command.
11.7 LBA High Register
This register contains Bits
When
11.8 LBA Low Register
This register contains Bits
When
11.9 LBA Mid Register
This register contains Bits
When
46/167