Travelstar 5K160 (SATA) Hard Disk Drive Specification
Starting LBA for test span 2 | 8 | 12A | R/W |
Ending LBA for test span 2 | 8 | 1Ah | R/W |
Starting LBA for test span 3 | 8 | 22h | R/W |
Ending LBA for test span 3 | 8 | 2Ah | R/W |
Starting LBA for test span 4 | 8 | 32h | R/W |
Ending LBA for test span 4 | 8 | 3Ah | R/W |
Starting LBA for test span 5 | 8 | 42h | R/W |
Ending LBA for test span 5 | 8 | 4Ah | R/W |
Reserved | 256 | 52h | Reserved |
Vendor specific | 154 | 152h | Vendor specific |
Current LBA under test | 8 | 1ECh | Read |
Current span under test | 2 | 1F4h | Read |
Feature flags | 2 | 1F6 | R/W |
Vendor specific | 4 | 1F8h | Vendor specific |
Selective self test pending time | 2 | 1FCh | R/W |
Reserved | 1 | 1FEh | Reserved |
Data structure checksum | 1 | 1FFh | R/W |
| 512 |
|
|
Figure 94 Selective
14.40.8Error Reporting
The following table shows the values returned in the Status and Error Registers when specific error conditions are encountered by a device.
Error Condition
A S.M.A.R.T. FUNCTION SET command was received by the device without the required key being loaded into the LBA High and LBA Mid registers.
Status Register 51h
Error Register 04h
A S.M.A.R.T. FUNCTION SET command was received | 51h |
by the device with a subcommand value in the Features |
|
Register that is either invalid or not supported by this |
|
device. |
|
A S.M.A.R.T. FUNCTION SET command subcommand | 51h |
other than S.M.A.R.T. ENABLE OPERATIONS was |
|
received by the device while the device was in a |
|
“S.M.A.R.T. disabled” state. |
|
The device is unable to read its Attribute Values or | 51h |
Attribute Thresholds data structure. |
|
The device is unable to write to its Attribute Values data | 51h |
structure. |
|
Figure 95 S.M.A.R.T. Error Codes
04h
04h
10h or 40h
10h or 01h
146/167
